RPM R/C Products Threaded Hinge Pins- TRA X-Maxx RPM70510

$10.63
Write a Review
SKU:
RPM70510
UPC:
672415705100
Shipping:
Calculated at Checkout
RPM R/C Products Threaded Hinge Pins- TRA X-Maxx RPM70510

Out of stock

In response to customer demand, were proud to release a set of threaded hinge pins for the Traxxas X-Maxx. RPM Threaded Hinge Pins work with stock Traxxas A-arms as well as RPM A-arms, are manufactured from stainless steel and are tough as nails! If youve lost or damaged your stock hinge pins, or perhaps youre tired of Losing those tiny hinge pin retaining screws, give RPM threaded hinge pins a shot and never look back! Tech

NOTES:
RPM Threaded Hinge Pins are 4mm x 56mm and work in the outer A-arm hinge pin location. Each kit comes with 4 threaded hinge pins and 4 M3 locknuts. Our hinge pins can be used as a replacement for CEN GS025 hinge pins as well but RPM versions use a 3mm locknut instead of a 4mm version. When used with the X-Maxx (using stock or RPM A-arms), some minor modification of the A-arms is required for the hinge pins to fit (see instructions for more information). GS025 Replacement: Please note, RPM replacement hinge pins use a smaller M3 lock nut, versus the stock M4 locknut that comes with the CEN #GS025. If the RPM locknut is too small for your application, a small 3mm washer may be used (not included). When used with the Traxxas X-Maxx: Some minor modification is required for RPM Threaded Hinge Pins to work with either stock Traxxas or RPM A-arms. Using a #22 drill (4mm), carefully remove the small shoulder in the outer hinge pin hole, opposite the hinge pin retaining screw in the Aarm. This slight modification, when done properly, will not void the warranty on your RPM A-arms.