Castle Creations Receiver Harness: MAMBA Monster X 011-0106-00 CSE011-0106-00

Mamba Monster X Receiver Harness Connection Instructions To Remove the Receiver Harness: Place slight pressure with thumb on capacitor shroud (Figure 1). Grip the harness close to the 8 pin connector and pull gently, at a slight angle away from ESC, to remove the harness from the ESC pin header (Figure 2).

NOTE:
Do not yank or forcefully pull harness out of ESC. May cause damage to ESC or harness. To Replace the Receiver Harness: Place slight pressure with thumb on capacitor shroud (Figure 1). Following the color coded wiring diagram provided on the Monster X label, place the 8 pin connector onto the ESC pin header (Figure 3).

NOTE:
Misalignment of the harness will prevent the ESC from operating. Be sure that the brown wire is plugged in next to the negative (-) black power wire. Gently press on the 8 pin connector to fully engage with the ESC pin header. Reconnect cooling fan and receiver connections.